Leica DISTO - Error Messages

Error  Code
Description
Corrective Measure
154
Transverse tilt >20°
Hold the instrument without any transverse tilt
156
Transverse tilt > 10°
Hold the instrument without any transverse tilt
160
Main tilt direction, angle too high (>45°)
Measure angle up to +/- 45°
162
The calibration has not been
accomplished on a leveled
surface and the calibration value
is respecitvely within an ineligible
area.
Calibrate the device on an absolute
horizontal leveled surface.
203
Wrong measuring sequence for Pythagoras measurements
Measure in correct sequence
204
Calculation error
Repeat procedure
206
No endpiece detection
Attach the endpiece properly. If error still occurs, replace the endpiece
217

Measuring module error

   Contact Us

240
Data transfer error
Repeat procedure
245
2nd button pressed although no
Bluetooth connection exists.
Establish Bluetooth connection
252
Temperature too high, above 50°C
Cool down the instrument
253
Temperature too low, below 0°C
Warm up instrument
255
Receiver signal too low, measuring time too long, distance too long
Use target plate, measuring time > 10 sec.
256
Receiver signal too strong
Use target plate (white side)
257
Erroneous measurement, too much   backlight
Use target plate
260
Laser beam was interrupted
Repeat measurement
272-276

 Measuring module error

Contact Us
279

 Measuring module error

   Contact Us

285-291

 Measuring module error

   Contact Us

297-299

 Measuring module error

   Contact Us

402

 Measuring module error

   Contact Us

404

 Measuring module error

   Contact Us

501-503

 Measuring module error

   Contact Us

651

 Measuring module error

   Contact Us

801-803

 Measuring module error

   Contact Us

Previous Page

 
© 2005 - 2024 Merlin Lazer http://www.merlinlazer.com - Printed: 22 May 2024