Leica DISTO - Error Messages

Error  Code	Description	Corrective Measure
154	Transverse tilt >20°	Hold the instrument without any transverse tilt
156	Transverse tilt > 10°	Hold the instrument without any transverse tilt
160	Main tilt direction, angle too high (>45°)	Measure angle up to +/- 45°
162	The calibration has not been accomplished on a leveled surface and the calibration value is respecitvely within an ineligible area.	Calibrate the device on an absolute horizontal leveled surface.
203	Wrong measuring sequence for Pythagoras measurements	Measure in correct sequence
204	Calculation error	Repeat procedure
206	No endpiece detection	Attach the endpiece properly. If error still occurs, replace the endpiece
217	Measuring module error	Contact Us
240	Data transfer error	Repeat procedure
245	2nd button pressed although no Bluetooth connection exists.	Establish Bluetooth connection
252	Temperature too high, above 50°C	Cool down the instrument
253	Temperature too low, below 0°C	Warm up instrument
255	Receiver signal too low, measuring time too long, distance too long	Use target plate, measuring time > 10 sec.
256	Receiver signal too strong	Use target plate (white side)
257	Erroneous measurement, too much   backlight	Use target plate
260	Laser beam was interrupted	Repeat measurement
272-276	Measuring module error	Contact Us
279	Measuring module error	Contact Us
285-291	Measuring module error	Contact Us
297-299	Measuring module error	Contact Us
402	Measuring module error	Contact Us
404	Measuring module error	Contact Us
501-503	Measuring module error	Contact Us
651	Measuring module error	Contact Us
801-803	Measuring module error	Contact Us

Previous Page